Tekmar 032 Timer User Manual download pdf

- Data Brochure

Timer 032

D 032

12/08

Installation

STEP ONE

———————

GETTING READY

Check the contents of this package. If any of the contents are missing or damaged, please contact your wholesaler or tekmar sales

representative for assistance.

Type 032 Includes: One Timer 032, Data Brochure D 032

STEP TWO

———————

REMOVING THE FRONT COVER

Place a screwdriver or similar object into the small slot located in the top of

the timer. Push the screwdriver against the plastic tab and pull the top of the

front cover so that it pivots around the bottom edge of the base.

STEP THREE

——————

MOUNTING THE BASE

Mount the base directly to the wall using two #6 1” screws. The screws are

inserted through the mounting holes and must be securely fastened to the

wall. If possible, at least one of the screws should enter a wall stud or similar

surface. If the timer is to be mounted to a 2” x 4” electrical box, order an Adap-

tor Plate 007. This plate mounts to the electrical box and the timer mounts to

the plate.

enu

Item

Remove cover

Push tab

#6 1" screws

The tekmar Timer 032 is a microprocessor-based timer which can be programmed to provide up to

two occupied and two unoccupied events each day. The timer can be programmed for either a 24 hour

schedule or a 7 day schedule. The internal SPST relay operates based on the schedule programmed by

the user. The user can override any programmed schedule either temporarily or permanently.

In the event of a power loss, the programmed schedule information is permanently retained in memory.

The clock continues to operate for up to four hours using a batteryless backup.

Sequence of Operation

The timer has an internal relay that switches on and off according to the schedule programmed

by the user and the DIP switch located in the back of the timer.

If the DIP switch is set to Relay NO (normally open), the contact is open during an occupied

event and is closed during an unoccupied event. If the timer is to be used in conjunction with

a tekmar reset control, the DIP switch must be set to the Relay NO setting.

If the DIP switch is set to Relay NC (normally closed), the contact is closed during an

occupied event and is open during an unoccupied event.

DIP Switch

ela

NC / Rela

24 V

ela

4 V

(

)

2 A

1 2 3 4

Summary of Contents

Page 1 - - Data Brochure

Page 2 - Timer 032

Page 3 - DISPLAY LIGHTING

Page 4

Comments to this Manuals

No comments

Tekmar 032 Timer User Manual

Browse online or download User Manual for Sensors Tekmar 032 Timer. tekmar 032 Timer User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Sensors Tekmar 032 Timer